I’m putting my ball joints in my knuckle, and installing the knuckle on my Dana 44. It’s a little bit tricky to get the right “preload” on the ball joints, so I thought I would explain the process of how to install the ball joint in the Dana 44 with the correct preload.

1. Clean up knuckle
2. Press ball joints into knuckle
3. Slide the knuckle onto the axle
4. Thread on the lower locking nut and tighten down to 90 ft lbs
5. Thread the adjuster nut all the way into the upper ball joint
6. Using a luggage scale to measure pre load on knuckle
7. Thread the castle nut on the top ball joint

00:00 Introduction
01:14 Tighten bottom ball joint nut to 90 ft-lbs
01:56 Install upper adjuster sleeve
05:02 Removing powder coat
06:10 Setting preload to 25 ft-lbs
08:32 Tighten upper ball joint nut to 100 ft-lbs

Thanks for watching and be sure to SUBSCRIBE so you'll have more Early Bronco video's in your inbox! 📬

👕 10% Off Shirts! Use promo code: YOUTUBE [ Ссылка ] 👕

🛠 Here are some of my favorite tools 🛠
[ Ссылка ]

👉🏼 My steering wheel 👉🏼 [ Ссылка ]

➡️ [ Ссылка ] ⬅️

🎥 SUBSCRIBE: [ Ссылка ]
📷 INSTAGRAM: [ Ссылка ]
💻 FACEBOOK: [ Ссылка ]

#earlybronco #classicbronco #fordbronco

свернуть