If you're struggling to figure out how to properly set up your FrSky Stabilized Receiver, this guide has you covered! In this step-by-step tutorial, I’ll walk you through the complete setup of a Pilot-RC Extra NG with an Archer SR10+ RX using Ethos 1.6.0. Whether you're new to stabilizers or looking for a quick refresher, this video will make your setup process smooth and efficient.

* I forgot to mention: to use any of the 6 buttons at the bottom of the radio the way I'm doing it, make sure to set "Function Switches" to "Momentary" in your "Edit Model" page.

If you haven't check out my video with the step-by-step process to update your TX to Ethos 1.6: [ Ссылка ]

🔧 What’s Covered in the Video:
- Installing the Stabilizer Config from Ethos Suite.
- Configuring gyro mode and assigning gain switches.
- Setting up callouts for gyro gain for easy adjustments.
- Performing Gyro 6-Axis Calibration for precision stabilization.
- Calibrating gyro banks and exploring advanced settings.
- Adjusting PWM centers, setting min/max endpoints, and verifying channel directions for optimal control.

Whether you're fine-tuning your model or starting from scratch, this tutorial ensures your stabilizer works flawlessly. Let’s get your plane flying with confidence!

Contents:
00:00 Intro
00:50 Create new model
03:00 Install Stabilizer Config
03:38 Register and bind receiver
04:42 6-Axis calibration
06:51 3-position switch Gyro mode
08:04 Gain adjustment with momentary switches
11:19 Voice callout for gain
14:08 Confirm outputs mapped correctly
15:07 Setup banks 1 and 2 and check gyro directions
18:03 Setup outputs pwm center, max/min and ch direction.
21:29 Stabilizer groups calibration
24:00 Final checks
25:58 Fine tuning gains
27:10 Channels without stabilization
28:06 Notes on gyro gains and trim/endpoint changes

свернуть