This is part 4 in the series where I am attempting to rescue this beautiful Singer Featherweight 221K Centenary edition sewing machine.

See the index below for subjects covered in this video.

Part 1 - [ Ссылка ] reveals what the machine had been converted to, assessing the donor parts machine and fixing the issue with the machine tripping the mains circuit breaker.
Part 2 - [ Ссылка ] shows removal of the parts from the donor machine.
Part 3 - [ Ссылка ] shows installation of the feed mechanism parts.

Please consider helping out the channel by becoming a patron at [ Ссылка ] - Contributions go towards the running of the channel and you get early access to some videos. You'll also get access to exclusive content.

Web Site - [ Ссылка ]

Index:
0.00 - Introduction
2:09 - Stop the press!
3:45 - Setting up the feed linkages
9:57 - Installing the lower shaft
12:50 - Installing the needle bar
14:00 - Molly the cat turns up
14:30 - Setting the hook to needle clearance
26:52 - Setting the hook timing
27:41 - Checking and setting needle bar height
29:23 - Stitch length/reverse lever installation
30:19 - Feed dog and throat plate installation and adjustment
33:21 - Oiling hook and lower mechanisms and tightening bearing grub screws
34:27 - Presser bar installation and adjustment
37:08 - More oiling and a light clean
38:24 - Installing the hand wheel and stop motion clutch and adjusting
39:52 - Installing the face plate and greasing motor bearings
42:00 - Greasing the gears
43:40 - The power plug is installed and installing the base plate and bed extension
45:35 - The bonus video on Patreon
46:32 - Winding a bobbin
47:33 - Installing the bobbin and bobbin case, threading and test sewing
49:22 - Conclusion and thank you.

свернуть