I got annoyed with measuring to the center of boards if I'm drawing a line down the middle so I decided to make a DIY center finder. Yes you can buy these but I wanted to use bearings with mine so it glides easier. I added a link below to a basic one you can buy if you're not interested in making one yourself.
🖥️ Website: [ Ссылка ]
🔨 Tool links (Amazon links are affiliate links which I may earn a commission from if items are purchased, at no additional cost to you, however, they are not sponsored products):
Video Specific:
Milescraft center finder: [ Ссылка ]
bearings: [ Ссылка ]
Safety Gear
- Micro jig narrow rip push block: [ Ссылка ]
- Micro jig paddle push block: [ Ссылка ]
- Milescraft push stick: [ Ссылка ]
- ISOTunes ear protection: [ Ссылка ]
- 3M work tunes [ Ссылка ]
Measuring
- FastCap measuring tape: [ Ссылка ]
- Setup blocks: [ Ссылка ]
Sanding
- Bosch sander: [ Ссылка ]
Saws
- Bosch job site table saw: [ Ссылка ]
- Bosch track saw: [ Ссылка ]
Joining
- wen biscuit joiner: [ Ссылка ]
Drilling
- Forstner Bit Set: [ Ссылка ]
Other
- auto vacuum switch: [ Ссылка ]
- 2P10 super glue and activator: [ Ссылка ]
- Bosch dust extractor: [ Ссылка ]
- WEN air cleaner: [ Ссылка ]
- HDPE miter bars: [ Ссылка ]
- Toggle clamps: [ Ссылка ]
