Step 1: Clearing the code (Button A for the left button, button B for the right button)
1. Press and hold buttons A and B of the new remote control at the same time until the LED flashes 2 times and then goes out.
Release button B and keep button A pressed.
2. Press button B 3 times, LED starts to flash rapidly, release button A.
3. Check: Press and hold any button, LED flashes 2 times and then goes out.
Step 2: Cloning
1. Place the old remote as close as possible to the new remote.
2. Press and hold the button on the old remote, then press and hold the button on the new remote. The LED of the new remote flashes a few times and then lights up long/flashes fast.
3. button A is cloned, repeat the above steps to clone button B.

Trouble shooting
Question 1: When I press and hold buttons A and B on the new remote control when clearing the code, LED light is always on?
Answer 1: Because both buttons are not pressed at the same time.
Both buttons must be triggered at the same time.

Question 2: When cloning the new remote control LED just flashes 2 times and then goes out？
Answer 2: The new remote control did not receive the signal successfully.
Try sticking the two remotes back to back and start cloning again.

свернуть