Learn to replace a pressed wheel bearing in a Ford, specifically a 95 Ford Windstar, but this method will be similar for all pressed bearing vehicles.
The main steps are to take off the spindle nut, tire, brake caliper, and rotor. Then remove the bolts from the lower control arm ball joint, tie rod, and strut. Remove the steering knuckle, then press out the bearing and hub/spindle. Then press in your new bearing and hub/spindle. This job is a little more complex but can still be easily done by any amateur mechanic. You will save $400-1000 depending on your vehicle.

Here is how to Replace a Hub Bearing Assembly (rear wheel drive): [ Ссылка ]
Here is how to Replace a Hub Bearing Assembly (front wheel drive): [ Ссылка ]
Bearing Press Tool: [ Ссылка ]

**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Thursday**

-Website: [ Ссылка ]
-Facebook: [ Ссылка ]
-Twitter: [ Ссылка ]
-Instagram: [ Ссылка ]
-Subscribe Here: [ Ссылка ]
-YouTube Channel: [ Ссылка ]

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.

свернуть