Sunwing Boeing 737-800s Aircraft at Waterloo Airport Close Up [4K60]
C-FFPH, C-FWGH
#Boeing737 #Boeing #aircraft #airplane #Planespotting
There is one incident report on C-FWGH: this Boeing 737-800 damaged a runway approach light following a long takeoff from Belfast in 2017.
Thomson Airways flight BY1526, a Boeing 737-800, damaged a runway approach light following a long takeoff from Belfast International Airport. The aircraft was operated by a Canadian airline, Sunwing Airlines, on behalf of Thomson Airways on a flight from Belfast International Airport to Corfu, Greece.
At some point during the cockpit preparation, a figure of -47°C was entered into the Flight Management Computer (FMC) as the outside air temperature (OAT). The FMC uses the OAT when calculating the value of N1 which will produce the engine’s rated thrust.
At a lower OAT, the engine will require a lower value of N1 to achieve this rated thrust. Therefore, entering an incorrect and abnormally low OAT, causes the FMC to calculate a value of N1 (and therefore thrust) significantly below that required to produce rated thrust in the actual conditions. Neither pilot noticed the error. Having completed the performance calculations, the crew reduced the takeoff thrust further by entering into the FMC a correctly-calculated assumed temperature thrust reduction of 47°C.
At 14:12 hrs the aircraft began to push back off the parking stand for its departure. During the pushback, the ground crew noticed that one of the nose landing gear tyres had a patch of worn rubber which they brought to the attention of the pilots. An engineer was called to look at the tyre and concluded that it needed changing. As a result, the aircraft returned to the parking stand and the engines were shut down. The engineers changed both the nose landing gear tyres, as is standard practice, and the aircraft was again ready to depart at 15:21 hrs. During this period the co-pilot updated the weather information from the ATIS and noted that the OAT had increased by 1°C. He recalculated the takeoff performance, which the commander checked before entering the new details in the FMC. He used 48°C to replace the previously-entered value for the assumed temperature thrust reduction but used an incorrect value of -52°C to replace the previously-entered (and incorrect) value for the OAT. The FMC used this information to calculate a thrust setting for takeoff of 81.5% N1. The aircraft pushed back from its parking stand at 15:21 hrs, and the flight crew started both engines before taxiing for departure from runway 07.
At 15:39 hrs, C-FWGH was cleared for takeoff on runway 07 from taxiway D, which gave a Takeoff Run Available (TORA) of 2,654 m. During the takeoff, at a speed of around 120 to 130 kt, the crew realised that the aircraft was not accelerating normally. They estimated, during post flight interviews, that they reached V1 with around 900 m of the runway remaining and rotated shortly afterwards. The aircraft, which was seen by multiple witnesses, took a significant time to lift off before climbing at a very low rate. After the aircraft lifted off from the runway, one of the aircraft tyres struck a runway light, which was 36 cm tall and 29 m beyond the end of the TORA. After takeoff, the crew checked the aircraft's FMC which showed that an N1 of 81.5% had been used for the takeoff. This figure was significantly below the required N1 setting of 92.7%.
It appeared that the FMC software version fitted to C-FWGH, U10.8A, predated revision U12.0, which features a crosscheck between the OAT entered by the crew and that sensed by the external temperature sensor.
