Will this jig slide well for making box joints with the homemade router table? My idea is to reduce the sliding surface, which is why I’m using some round wood rods as runners. Also, the base of the jig is slightly elevated above the table. Instead of choosing the size of the router bit, I cut four pieces of plywood to make a jig that can use four straight router bits of different sizes for wood. However, my mistake was using low-quality plywood, which caused one of the pieces to suffer so much tear out that I couldn’t use it.

I find the trick interesting that allows me to make sure the side pins of the joint are the same size, even though they are narrower than the router bit I used.

When adjusting the distance from the indexing key to the router bit, if the piece between them fits tightly, the pin will be thin and will fit loosely into the sockets when making the joint. If the piece is loose between the indexing key and the router bit, the pin will be thick and fit very tightly.

I should have made the indexing keys longer and shorter in height.

In a future video, we’ll see another very interesting trick using this woodworking jig.

How to make the router table for woodworking that I used in the video:
[ Ссылка ]

Parts of the video:

00:00 Make a base for the jig that slides well on the router table.
02:19 Sanding tips to level the height of the wooden rods with the table.
02:49 Assemble the parts of the finger joints jig.
04:22 Prepare the jig to cut box joints of different sizes.
09:30 Trick to avoid tear out when routing plywood.
09:48 Trick to make the side pins of the joints the same size.

Thanks for subscribing.

свернуть