Flex Innovations Super PNP Series - Pirana Setup with Futaba & Aura 5 Lite
This video shows you how to setup a basic Flex Innovations Super PNP model using Futaba. All of the products used were taken right out of the boxes and connected to show you how easy it is to setup a Flex Innovations Model. We will have more advanced videos in the future that will cover more advanced topics.
**PLEASE REMOVE THE PROP WHILE SETTING UP YOUR AIRPLANE**
TX: Futaba 14SG
RX: Futaba R2001SB
In this video we connected the Futaba R2001SB to Aura using the servo cable provided. Aura 5 is using the most up-to-date firmware at the time of this video. After binding the RX with Aura connected we did a wiggle test and confirmed the control surfaces and gyro are moving the correct directions.
After confirming the motor spins the correct direction you can install the prop for the maiden flight. During the first flight trim out the plane as needed, but land in the flight mode that we were trimming. Keep the TX on and in the flight mode that was being trimmed.
Aura 5 Lite features BIND and TRIM buttons. Aura 5's Quick Trim can be accessed by pressing and holding the TRIM button for a few seconds until Aura's LED starts to flash Blue Slowly. Press and hold the TRIM button a 2nd time for a few seconds until Aura's LED starts to flash Blue fast. You can NOW CENTER YOUR TX TRIMS and they will be saved to Aura. You can power down the plane at this time or hold the trim button down until Aura's LED turns Solid Green and Solid Orange.
FT Aura 5 Lite Quick Guide: [ Ссылка ]
Subscribe!
[ Ссылка ]
Facebook: [ Ссылка ]
Instagram: [ Ссылка ]
Twitter: [ Ссылка ]
Subscribe!
[ Ссылка ]
Facebook: [ Ссылка ]
Instagram: [ Ссылка ]
Twitter: [ Ссылка ]
