In this video, I show you how to spray raptor liner in the bed of your truck.

🚨🚨🚨Want to wear cool Minute Masters merch OR get stickers?? click this link👇
[ Ссылка ]

🔥Subscribe here: [ Ссылка ]

🚧 Links for the stuff I used in the video are below:👇
👉 Raptor Liner 6 QT Kit: [ Ссылка ]
👉 U-Pol adhesion promoter: [ Ссылка ]
👉 Eastwood Rust Converter: [ Ссылка ]
👉 Eastwood Rust Encapsulator: [ Ссылка ]
👉 Blue tape with Masking Film attached: [ Ссылка ]
👉 Roll of sticky back sandpaper 80 grit: [ Ссылка ]

**Self etching primer, 3M scuff pads, and roll of blue tape I purchased at hardware stores.**


This 1995 F150 is particularly challenging because it's rusty and dented. First, I had to scrape off the heavy scale rust. Then, I had to treat/use rust converter on the rust to neutralize it. Once the rust was neutralized, I was able to sand/scuff the bed so that that raptor liner could adhere to the metal properly.
Second, I use rust encapsulator paint on all the rusted areas and I used self etching primer for all the bare metal spots. I let these two paints dry, then I used U-Pol's adhesion promoter in all the hard to reach areas as well as any areas that I felt weren't sanded as deeply.

Third, I set up the raptor liner spray gun (MUST NEED: female threaded air compressor quick disconnect fitting and teflon tape).
I mixed the hardener and raptor liner to the correct ratio, shook it for two minutes, and started spraying. Allow product to flash dry between coats. the directions out lines the timing.

Minor note: If the raptor product gets wet before the 72 hour dry period it WILL NOT AFFECT the integrity of the product. White dots will appear in the raptor liner every time it rains. Once the water on the bed dries up, the white dots will slowly disappear, but will reappear each time the bed gets wet. This will continue for a few months and will eventually go away.

We Are One by Vexento [ Ссылка ]
[ Ссылка ]
Free Download / Stream: [ Ссылка ]
Music promoted by Audio Library [ Ссылка ]

Welcome to The Minute Masters YouTube Channel where I (Stevie) show you how to repair and upgrade all Ford F series trucks and Broncos from 1980-1997. So hit that subscribe button and be ready to resurrect your baby!🤙

The project is my 1995 Ford F150 XL 2wd 8 foot bed.

As an Amazon Associate I earn from qualifying purchases.

свернуть