In this video, Dylan from Alarm Grid discusses the location of the Qolsys IQ Panel 4 power button and outlines when and how you should use it. When powering down the IQ Panel 4 always go through the menu. Failure to do so can cause panel damage. The power button is located on the right-hand edge of the panel as you face it. It is about halfway between the top right corner and the bottom right corner. It is slightly recessed.
Some of the reasons to power down the IQ Panel 4 include when adding hardware, such as a Zigbee daughter card. Also, when replacing a worn-out battery you should properly power down the panel before removing and replacing the old battery. Finally, as a part of troubleshooting, you may be instructed to power the panel down and back up. There is a reboot option within the menu, but at times, it is best to power down completely and then power back on.
To power the panel down, tap the gray bar at the top of the screen, then go to Settings, then Advanced Settings. Enter the Installer, Dealer, or Master Code. They are 1111, 2222, or 1234 respectively, by default. After entering the code, tap "Power Down." When the screen goes dark and all LEDs turn off the system is powered down.
If you're installing hardware, such as a daughter card, we recommend you unplug the battery and the power cable after you power the panel down through the menu. Once this is done, perform the installation. Reconnect the battery and then the power adapter (in that order). If the panel doesn't automatically begin to boot up, press and hold the power button for three (3) seconds. The LEDs will light and within a few seconds, the screen will light up and the panel will boot up.
[ Ссылка ]
[ Ссылка ]
Ещё видео!