Build your own 12V, 2000W solar setup by following these simple steps. There's no technical knowledge or skills needed ... plus there's no confusing verbiage used in this video. Here are all the items covered in this video:
Wiring chart
* [ Ссылка ]
Book
* This book was extremely helpful detailing everything you need to know: [ Ссылка ]
Components
* Inverter (2000W): [ Ссылка ]
* Charge controller (40 Amp MPPT): [ Ссылка ]
* Battery (12V, 100Ah LiFePO4 self-heating): [ Ссылка ]
* Solar panel (100W): [ Ссылка ]
* Bus bar (250 amp, red): [ Ссылка ]
* Bus bar (250 amp, black): [ Ссылка ]
* 12V fuse block: [ Ссылка ]
Cables
* Connect batteries in parallel: [ Ссылка ]
* Battery / inverter cable: [ Ссылка ]
* Battery / charge controller cable: [ Ссылка ]
* Solar extension cable: [ Ссылка ]
* 2|0 AWG cable (red and black): [ Ссылка ] + 2|0 AWG cable lugs: [ Ссылка ]
* 4|0, 2|0, 1|0, 2, 4, 6, 8 AWG cable: [ Ссылка ]
* 12 AWG cable: [ Ссылка ]
Cable management
* [ Ссылка ]
Fuses
* 200 amp fuse (used in 2 places: on battery and inverter): [ Ссылка ]
* Inline MC4 10 amp fuse (used to connect solar panels to charge controller): [ Ссылка ]
* 40 amp fuse (used after charge controller): [ Ссылка ]
* Fuse holder: [ Ссылка ]
Switch
* High volt, low amp (disconnects solar panels): [ Ссылка ]
* High amp, low volt (disconnects batteries from system): [ Ссылка ]
Monitor
* BT-2 bluetooth module (connects to batteries for app monitoring): [ Ссылка ]
* BT-1 bluetooth module (connects to charge controller for app monitoring): [ Ссылка ]
* Shunt/battery monitor (monitor battery status directly): [ Ссылка ]
Tools
* Cable stripper (optional, I bought it but never used it): [ Ссылка ]
* Cable wire lug crimper plus cable cutter: [ Ссылка ]
* Cable lugs + shrink wrap: [ Ссылка ]
* Ratchet with rubber grip (I bought this as I wanted rubber on the end of the handle to avoid touching the end of the handle on posts by accident): [ Ссылка ]
* Heavy AWG crimping tool (need it for the 2|0) cable to connect the batteries to the inverter: [ Ссылка ]
* Wire insulation cutter/stripper: [ Ссылка ]
Or, if you'd prefer to pick up a kit with all of these pieces combined (to save money), you can check out these options:
* [ Ссылка ]
Skip around with these timestamps:
* Classroom: 1:21
* -- Wiring: 5:39
* -- Cable lugs: 8:13
* -- Fuses: 9:06
* -- Switches: 10:02
* -- Bus bars: 10:33
* -- Shunts: 11:11
* -- Layout: 11:26
* Lab (inverter to battery): 12:04
Follow me on:
Instagram - [ Ссылка ]
Facebook - [ Ссылка ]
Twitter - [ Ссылка ]
Website: [ Ссылка ]
#diy #solar #guide
