I currently tighten my battery terminal studs to 42 inch pounds. I think 95 was a bit much!
0:25 Parallel Pack Balancing
6:05 Balance leads
8:00 Building Sense Leads
14:00 Connecting Sense Leads
20:20 Measuring Balance Leads for Accuracy
22:04 Turning on BMS
22:40 Load Test
30:28 Putting in box
This is how I built a 100AH 12.8V Solar Storage Battery and some of the parts that did or didn't work for me. Note about the cells I link to here, I had some quality issues in later orders from my seller so I have changed to a different Alibaba seller. Hence them looking different.
Battery Terminals: [ Ссылка ]
4 Gauge wire: [ Ссылка ]
Wire Strippers: [ Ссылка ]
Soldering Iron: [ Ссылка ]
Solder: [ Ссылка ]
Jumper Wires: [ Ссылка ]
Fish Paper: [ Ссылка ]
Kapton Tape: [ Ссылка ]
BMS: [ Ссылка ]
Torque Wrench: [ Ссылка ]
LiFePo4 Cells: [ Ссылка ]
Toolbox: [ Ссылка ]
As an Amazon Associate I earn from qualifying purchases.
As a Battery Hookup affiliate I earn from some purchases made through links on this page.
#DIY #SolarPanels #Growatt
