For more details you can see this article: [ Ссылка ]
A water pump is a device that is used to move water from one location to another. It can be used for a variety of applications, such as supplying water to a building, draining water from a flooded area, or irrigating crops. There are many different types of water pumps, including centrifugal pumps, positive displacement pumps, and submersible pumps.
To control a water pump with an ESP32 and a relay using MicroPython, you would need the following components:
- ESP32 development board
- Relay module
- Water pump
- Jumper wires
- Breadboard (optional)
Here are the steps to control a water pump with an ESP32 and relay using MicroPython:
1- Connect the relay module to the ESP32 development board using jumper wires. The relay module should have a VCC pin, a GND pin, and an IN pin. Connect the VCC pin to a 5V pin on the ESP32 board, the GND pin to a GND pin on the ESP32 board, and the IN pin to a GPIO pin on the ESP32 board (e.g., GPIO 23).
2- Connect the water pump to the relay module. The pump should have a positive wire and a negative wire. Connect the positive wire to the normally open (NO) pin on the relay module, and connect the negative wire to a GND pin on the ESP32 board.
3- Write the MicroPython code to control the water pump. Here's an example code:
import machine
import time
# Set up the relay pin
relay_pin = machine.Pin(23, machine.Pin.OUT)
# Turn on the water pump
relay_pin.value(1)
time.sleep(10) # Run the pump for 10 seconds
# Turn off the water pump
relay_pin.value(0)
This code will turn on the water pump by setting the relay pin to HIGH, wait for 10 seconds using the time.sleep() function, and then turn off the water pump by setting the relay pin to LOW.
4- Save the code to the ESP32 board and run it. You can save the code using a tool like ampy, which allows you to transfer files to the ESP32 board. Once the code is saved, run it using the REPL or by running the
