Complete Universal Toilet Repair Kit Install by Korky | [ Ссылка ]
Hello and Welcome to Korky Toilet Repair.
Today we are going to install your new Korky Complete Universal Toilet Repair Kit.
The first step is to shut off the water supply to your toilet.
Then flush and hold the lever down to drain the water from your tank.
Sponge out the remaining water in your toilet tank.
Place a bucket underneath your toilet tank to catch any excess water.
Disconnect your water supply line and remove the mounting nut.
Remove the old fill valve.
Locate and remove all old nuts, bolts, and washers from the toilet tank.
Carefully lift up on the tank and remove it from the bowl.
Remove the old tank-to-bowl sponge gasket.
Remove the old mounting nut and pull the old flush valve and flapper out of the toilet tank.
Place your new Korky flush valve into the toilet tank, and slide the chipboard washer over the threads.
Hand-tighten the mounting nut.
Place the new red sponge gasket over the mounting nut threads.
Carefully set the tank onto the bowl.
Use the new bolts, rubber washers, washers, and hex nuts, included in the packaging to attach the tank to the bowl.
Apply downward pressure to keep the tank level as you tighten the nuts in an alternating fashion until the tank is stable.
Do not over tighten the nuts; doing so may cause the porcelain to crack.
Next, set the height of the flush valve.
Loosen the locknut and extend the overflow tube until the top of the overflow tube is one inch below the flush lever nut, then hand-tighten the locknut.
Now, turn the top of your new fill valve counter clockwise and pull up to fully extend.
Place the valve in the tank and press down on the fill valve until the corner of the white cover lines up with the top of the flush valve.
Lock the fill valve in place by twisting the upper half clockwise.
Make sure the rib on the top of the valve lines up with the pegs on the bottom half.
Attach the refill tube to your new fill valve.
Make sure the refill tube has a direct path to the flush valve.
When your fill valve is set, screw on the mounting nut until hand tight.
Push the refill tube towards the front of the tank to ensure the port is locked in place.
Insert the metal clip into the refill tube and attach the clip to the flush valve.
Then attach the flapper chain to the flush lever with minimal slack.
Reattach the water supply line.
Turn the water supply on to complete your installation.
Congratulations, You have successfully installed your new Korky Complete Universal Toilet Repair Kit.
Thank you for choosing Korky.
If you have any questions or need further assistance with your installation, please visit our website or call us at 1 800 528 3553.
