Set of videos that go over my experience with the AnyCubic Chiron 3D printer.
Unboxing, building, Setting up, programming and my first prints. I also have a Anycubic Delta, linear Plus printer -
So, after a couple years - I decided it was time to UPGRADE! : )
So, If you like these glimpses into my learning and use of 3D printers; you should get one :)
Just be sure to do a lot of research before buying one.
They are not one size fits all, The are NOT ready to print perfect prints right out of the box.
But, with a little work, they can be not only great fun, but a great educational tool -
and, you get to make really cool things!
Still, that cable for the hot end, there are only 9! wires in each 'wire'! I am, and suggest you do as well - make a NEW one!
Use IDE pc ribbon cable, an old VGA cord - anything thats got at least 28 to 24 gauge wire in it and at least four feets long
EDIT! ^^^ that didnt work so well for me :(
Ordered a new one from AnyCubic.
However - Looking into the Biqu B1, it has a type 'C' cable connector...?! If I can get the break out boards.... :)
ALL CREDITS go to JEFF BRODERICK for the Bantam Mount - And Dual 40mm Fangs -
[ Ссылка ]
And, Eliot ht -
[ Ссылка ]
The TMC 2208's that I am using -
[ Ссылка ]
Buy the Anycubic Chiron Here - [ Ссылка ]
Buy the Anycubic Delta here - [ Ссылка ]
Firmware and all software / information can be found here - Chiron -
[ Ссылка ]
Firmware and all software / information can be found here - Delta -
[ Ссылка ]
Slicer that I use Cure 4.5 -
[ Ссылка ]
AnyCubics Build video - Delta -
[ Ссылка ]
3D prints / ideas / objects -
[ Ссылка ]=
ZYL Tech Filament site - That I use exclusively on my Chiron printer
[ Ссылка ]
WYXWorks 1.75mm Filament - That I have used exclusively on my Delta printer -
[ Ссылка ]
And now the SKS board has come out! new file format and programmer needed?!
