1. Place a container under the dispenser outlet to capture the water used to clean the system (at least 1 litre capacity).
2. Plug in the unit, the tank empty warning light will illuminate.
3. With the water hopper in place (but not the filter) fill the hopper with 1 litre of freshly boiled water
4. wait for the tank empty warning light to go out. The water tank hot light will illuminate.
5. Press the cleaning mode button and hold for 2 seconds. The cleaning mode light will illuminate.
6. Wait whilst the boiled water is emptied from the tank, through the dispenser, into the container that you placed under the outlet in step 1.
7. The tank empty warning light will illuminate once the water has flushed through the system.
8. Discard the water captured in your container and replace it under the dispenser.
9. *Handling the filter cartridge by the top only: • Remove the filter cartridge from packaging • Remove sticker from the top of filter • Fill a bowl with potable (drinking) water • Fully submerge the cartridge in the water • Gently agitate until the bubbles cease fit inside the plastic hopper handling only the top when inserting.
10. Fill the hopper with cold water.
11. Wait for the tank empty warning light to go out.
12. Press the start/stop button. A red light will flash.
13. The appliance will dispense an amount of hot water
14. Press the start/stop button again. A green light will flash and an amount of water will be dispensed to finish the cycle.
15. Discard dispensed water. Your system is now ready to use.
