Click for more info and reviews of this Demco Straight Tongue Trailer Coupler:
[ Ссылка ]
Check out some similar Straight Tongue Trailer Coupler options:
[ Ссылка ]

[ Ссылка ]
Don’t forget to subscribe!
[ Ссылка ]

Full transcript: [ Ссылка ]
Today we're going to take a look at the Demco EZ-Latch Channel Tongue Trailer Coupler for the two and 5/16 diameter hitch ball. This one has a 21,000 pound weight capacity. Now this is a straight tongue coupler, it's made of a sturdy steel construction, it has a nice zinc finish on it. Offers corrosion resistance. It does meet the 200 hour salt spray rating, and it is a channel tongue coupler that will let you hook up your trailer to your tow vehicle, provides the connection point right here for your two and 5/16 diameter hitch ball. Now what's unique about this one, it uses the EZ latch coupler mechanism right here.

This ensures fast, simple, secure hookup and disconnect. Basically it will let you hook up when the latch is in the closed position like it is now, you just drop the coupler over the hitch ball, the latch will snap it into place and secure it.And I'm going to demonstrate that here's a two and 5/16 diameter hitch ball that it would fit on. So you can see if I just take that coupler, drop it on the top and you push down on it. You can see it snaps right into place. This has all stayed closed, and it snaps and secures it to the hitch ball.

And then to release it, just pull up all the way on the latch and it slides right off. Simple as that. There's no pin needed or safety clip to hold it into place. And again, just to show you, we close it, drop it on there, snaps right into place. The latch itself is a corrosion proof polymer nylon resin composite latch handle.

It's very durable and impact resistant. Now to lock this, you can lock this to your hitch ball so nobody takes it. Basically this hole right here is a 5/16 diameter hole. It goes all the way through. You can put a coupler lock pin lock all the way through there as long as you got to make sure it's a 5/16 diameter coupler lock.And it does have a minimum span width, from here to here is three inches.

You can put that lock pin through there, put the lock on this side and it'll lock it so nobody would take it. And again, this is a bolt on installation. You can notice on the side here it has the four bolt holes. Now the installation hardware to install this is not included. This part is made in the USA. Mounting, this is designed to mount to a three inch wide straight channel tongue. So you can see if I measure the inside to inside width on this is three inches. Again, the hitch ball, it's designed to fit onto is a two and 5/16 diameter hitch ball. And the weight capacity on this is 21,000 pounds. But that should do it for the review on the Demco EZ-Latch Channel Tongue Trailer Coupler for a two and 5/16 diameter hitch ball.

свернуть