This is my overview of all the tweaks and mods to the stock Geeetech prusa i3 X. Hope you like..
Also forgot to mention I did drill out the holes in the top acrylic frame where the z threaded rods pass through to allow movement and therefore less movement on the carriage.
Part of the z wobble problem was a not straight motor shaft on one of the z steppers which is apparently very common but rather than buy a bunch of them hoping to get a better one I chose to use the mods.

Here is the link for the thingiverse page with all the models I used to print parts from. Enjoy!

[ Ссылка ]

The list of parts needed for the same upgrades, Note: you will still need to by some hardware and print plastic parts as well.

1: Decent power supply that fits the frame.
ebay item# 171439919652
2: chrome rods -- you will need a air or electric grinder with a cutoff wheel to cut them.. pretty sure a hacksaw has no chance.
ebay item# 331047793540
3: High lubricity tip 0.4mm
ebay item# 321667110675
4: MK7 extruder gear
ebay item# 111660480858
5: new belt
ebay item# 151738871982
6: fan 52mm
ebay item# 161458943713
7: linear bearings lm8uu
ebay item# 181168182751

свернуть