Found a fun little surprise when I went to remove the Ball Joint on the Hawkeye WRX. Someone had sheared the bolt head on the Pinch Bolt clean off! If you've just sheared off the Pinch Bolt on your Subaru, or you just want to replace it with a better design. This video will show you what we did to drill out the bolt and replace it with a Thru-Bolt and Nut.
As always, like and subscribe! And don't forget to follow HET on social media at: [ Ссылка ]
Product Links:
Punch Set
[ Ссылка ]
Milwaukee Drill Kit
[ Ссылка ]
1/8" Drill Bit
[ Ссылка ]
13/64" Drill Bit
[ Ссылка ]
1/4" Drill Bit
[ Ссылка ]
13/32" Drill Bit
[ Ссылка ]
Cutting Lube
[ Ссылка ]
Chicago Pneumatic Air Hammer (Didn't get this on camera, but it was a huge help getting the rest of the bolt out after the threads were drilled out. HIGHLY RECOMMEND this or another reputable air hammer that suites your fancy if you are working in the salt belt, or any time you are trying to dislodge some highly rusted components. Plus, it will make you feel like Rambo. Use hearing protection. BRRAP BRRAP!!!)
[ Ссылка ]
Drift Punch Set
[ Ссылка ]
Trouble Light
[ Ссылка ]
Filming Equipment:
GoPro Hero7 Black
[ Ссылка ]
128 GB SD Card
[ Ссылка ]
Mic
[ Ссылка ]
Mic Adapter
[ Ссылка ]
Tripod
[ Ссылка ]
Disclaimer: Power tools are dangerous and can cause serious harm when used improperly. Make sure to use proper PPE. Any attempt to replicate the procedures and techniques displayed in this video is done so at your own risk and may void your factory warranty. Any injury to persons or property as a result of such an attempt is solely your responsibility.
