How to flash firmware via USB to STM32 devices via DFU (device firmware upgrade) and STM32 Cube Programmer. This way you do not need an ST-Link or similar programmer to flash firmware - however, you cannot set breakpoints, debug, and so on.
Note: this is only supported on certain STM32 microcontrollers (check the datasheet!).

Tag-Connect SWD Probe: [ Ссылка ]

[SUPPORT]
Free trial of Altium Designer: [ Ссылка ]

PCBA from $0 (Free Setup, Free Stencil): [ Ссылка ]

Patreon: [ Ссылка ]

Mixed-signal hardware design course: [ Ссылка ]

[GIT]
[ Ссылка ]

[TIMESTAMPS]
00:00 Introduction

00:24 Altium Designer Free Trial
00:43 JLCPCB and Git Repo

01:08 STM32 DFU Overview

01:58 Test Firmware
02:38 Generating Binaries

03:19 STM32CubeProgrammer and Flashing (BOOT0=1)
04:37 Run Mode (BOOT0=0)

ID: QIBvbJtYjWuHiTG0uCoK

свернуть