Automate your Bambu Lab P1 & X1 using only your slicer and stock parts with this in-depth tutorial. I have been using this setup for nearly three years, 3D printing thousands of designs throughout day and night with custom continuous printing and ejection codes.

Go visit this videos sponsor PCBWay at:
[ Ссылка ]

This guide includes every trick and tip I have learned along the way, free G-code files for you to use, and a few original ideas I haven’t seen anywhere else.

Hopefully, this will save you lots of “pick off and restart” work in the long run for parts that you are printing over and over again.

Download all start and end gcode: (free & no signup)
[ Ссылка ]

Let me know what you think in the comments below!


------------------------------------------------------------

👉🏻3D printing files & commercial license:
[ Ссылка ]

🛠️ Favorite 3D-printing equipment:
[ Ссылка ]

🔥 My favorite 3D printer:
[ Ссылка ]=
[ Ссылка ]= (Or this one if you are on a budget)

Social Media:
[ Ссылка ]

------------------------------------------------------------
Thank you for watching!

DISCLAIMER: Part of this video was sponsored by PCBWay
FTC Disclaimer: A percentage of sales is made through affiliate links

-- TIMESTAMPS –
00:00 - Intro
00:47 - Automation Optimized Startup Sequence P1 & X1
05:08 - In-Model Purge for Print Automation
08:37 - Optimised Cooldown Phase End G-code
12:03 - Safe Ejection Sequence End G-code
14:00 - Looping Prints on Bambu Lab Printers & Checklist
15:39 - Increase Automation Efficiency & Big Model Ejection

свернуть