Let’s learn how to setup and program NodeMCU ESP8266 using Arduino IDE. We’ll connect NodeMCU ESP8266 with laptop using MicroUSB cable. And then install ESP8266 specific software packages using board manager in arduino software. This will let us select NodeMCU1.0 ESP-12E module while programming NodeMCU in tools section. And finally, we’ll write arduino program to blink on board led on NodeMCU ESP8266 which is D4 Pin.

[SUPPORT]

►► Get FREE TRIAL of Altium Designer: [ Ссылка ]

►► Need Help? To Learn Embedded Systems: [ Ссылка ]

[TIMESTAMPS]
00.00 Introduction
01.02 Make sure device detected
02.36 Add board manager URL
03:14 Install ESP8266 boards
05:50 Select ESP-12E Module
07.12 Done uploading and blink LED

[LINKS]

►► Installation: [ Ссылка ]

свернуть