Making a catch all tray. What do you think of how it turned out?
- - - - - - -
I started out by using the item no. 56126 3/16" point roundover to ease the edges of the tray on the CNC making things a little easier. [ Ссылка ]
- - - - - - -
RPM: 18,000
Feed Rate: 50ipm
Plunge Rate: 25ipm
Depth per pass: .18"
- - - - - - -
Then I followed that up with a item no. 45982 3/4" bowl bit to carve out the center and give a nice round profile at the bottom edge of the tray. [ Ссылка ]
- - - - - - -
RPM: 18,000
Feed Rate: 40ipm
Plunge Rate: 20ipm
Depth per pass: .2"
Stepover: 29%
- - - - - - -
The item no. 46202-K Spektra™ 1/4" downcut bit cut the tray from the rest of the material. [ Ссылка ]
- - - - - - -
RPM: 18,000
Feed Rate: 80ipm
Plunge Rate: 40ipm
Depth per pass: .25"
- - - - - - -
After the tabs were cut the item no. MR0112 3/16" ball bearing mini roundover, [ Ссылка ] , to cut the tabs flush and added a little bit of a roundover to the bottom. Finally, a minute of sanding with 220g and this tray is ready for finish! #short #shorts
** Subscribe - [ Ссылка ]
** Shop the website - [ Ссылка ]
