Flush coolant/antifreeze from your engine and radiator. Easy. Use your garden hose to create pressure and flush engine as well as radiator – forwards and backwards. Keep your radiator, heater core, and engine clean. Flushing your coolant is good for the cooling system to prevent rust and to stop your car from overheating.
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. **
Step by step:
1) Locate the petcock valve underneath the radiator
2) Place a drain pan underneath the valve
3) Drain coolant from radiator
4) Remove thermostat, but reattach housing and hoses
See video: [ Ссылка ]
5) Remove the hoses leading to and from the radiator
6) Cover your alternator, spark plugs and electrical connectors so they don’t get wet
7) Use garden hose to flush engine – forwards and backwards
8) Use garden hose to flush radiator – forwards and backwards
9) Put everything back in place (don’t forget thermostat)
10) Fill up with coolant (50/50 mix) and deionized water
11) Go for a test drive
Disclaimer: Due to factors beyond the control of Pen-Pusher, I cannot guarantee against improper use or unauthorized modifications of this information. This video and all opinions are truthfully my own.
Pen-Pusher assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk.
Pen-Pusher recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Pen-Pusher, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result.
Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Pen-Pusher.
