In this video we’re going to check that everything works as it should on our newly klipper controlled 3d printer before we let it loose on a print.
What we are going to do before any homing, z offset, or bed leveling, is to verify that the heaters and stepper motors on our printer are being controlled correctly and that our stepper motor endstops are going to stop our printer from trying to tear itself apart.
*This series is sponsored by PCBWay*
[ Ссылка ]
*Commands*
M84 - Disable All Motors
M112 - Klipper Shutdown
SET_STEPPER_ENABLE STEPPER=stepper_x ENABLE=1
SET_STEPPER_ENABLE STEPPER=stepper_y ENABLE=1
SET_STEPPER_ENABLE STEPPER=stepper_z ENABLE=1
QUERY_ENDSTOPS
STEPPER_BUZZ STEPPER=stepper_x
STEPPER_BUZZ STEPPER=stepper_y
STEPPER_BUZZ STEPPER=stepper_z
*Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)*
*Raspberry Pi 5*
[ Ссылка ]
*Raspberry Pi Power Supply*
[ Ссылка ]
*Elecrow 5" HDMI Touchscreen*
[ Ссылка ]
*Klipper Setup Series*
Part 1 - [ Ссылка ]
Part 2 - [ Ссылка ]
Part 3 - [ Ссылка ]
Part 4 - [ Ссылка ]
Part 5 - [ Ссылка ]
Part 6 - [ Ссылка ]
Part 7 - [ Ссылка ]
Part 8 - [ Ссылка ]
Part 9 - [ Ссылка ]
Part 10 - [ Ссылка ]
..............................................................................................................................................................
BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.
[ Ссылка ]
You can also use the YouTube 'Thanks' button above if you prefer.
...............................................................................................................................................................
