In this video I choose, connect and configure my victron MPPT charge controller.
Settings for this controller are valid for other chargers too.
After watching this video you will be able to apply to correct settings to your charge controller.
In this video I show also how to configure the VE.smart networking.
In the second part of the video I connect the PV wires to the charge controller via the breaker box and solar combinerbox
After this video you will be able to choose the correct charge controller for your project, connect it safely and configure it wit the correct settings.
0:00 start & intro
1:17 Introduction to the victron charge controllers
1:41 Select the right victron charger for your project
3:21 Victron chargecontroller inside out
14:09 Victron VE.smart Networking configuration and demo
15:30 Connecting solar to your victron charger - challenges and safety
22:55 Conclusion
Link to DIY PV combinerbox you see few times in video: [ Ссылка ]
Here's a link to all parts used to built the powerwall:
[ Ссылка ] (adding as we go)
Link to cable cutter: [ Ссылка ] - [ Ссылка ]
Link to ferrules 6mm: [ Ссылка ] - [ Ссылка ]
Link to the victron solar charger manual with additional information:
[ Ссылка ]
For recording my YT clips I'm using a DJI pocket: [ Ссылка ]
Disclaimers:
This video is for information purposes only. Be aware building a powerwall is not like making a Bob Ross painting....mistakes can cause large unhappy accidents.
If you have no experience with electrical connections or solar, please contact an experienced technician.
Franky - EASYPOWERWALL
