5:20:09
It might have a tiny bit more time to cut off, but I am ready to put the linear rail on.
Follow for updates on how I did this. I'm making a very detailed video explaining everything.
Standard Speedboat Settings:
0.5mm width
0.25 height
Every other layer infill
2 Walls
3 Top and Bottom
Infill are lines (I'll explain this in the video I make in the future) at 10%
Retraction off, Pressure advance off
Speed 330mm/s
X Acceleration: 487500 (Stock motors, stock wheels)
Y Acceleration: 40000 (Stock motors, stock wheels)
Inland High Speed PLA slightly underextruding at 220C (Not the filament's fault)
Mods:
Dual Z from Creality (I think this counts still as stock motion), Wobble Z couplers, Oldham Coupler, Backlash Springs (Getting the Z binding to go away was a PITA. I threw the book at it.)
Klipper on RPi3
E3D clone, genuine heat break, CHC Volcano heater, No Name Melt Zone Extension
BMG Clone extruder
Filament runout sensor that was a waste of money as I don't have it set up in Klipper
PEI bed
