Are you admitted to Engineering or polytechnic or in any technical course and want to learn the drawing instruments used in the subject ‘Engineering Graphics’, then watch this video and my full course available at youtube.com/c/TechProSVBhaskar

Use links shown below for related videos:

Introduction to Engineering Graphics: [ Ссылка ]

Introduction to Projections of Solids: [ Ссылка ]

Projections of Solids in Initial Resting Position: [ Ссылка ]

Square Prism Inclined to One Reference Plane: [ Ссылка ]

Square Prism Inclined to Both Reference Planes: [ Ссылка ]

Cone Inclineds to One Reference Plane: [ Ссылка ]

Cone Inclined to Both Reference Planes: [ Ссылка ]

Cone Inclined to Both Reference Planes (Apex towards/away from observer):
[ Ссылка ]

Hexagonal Prism Inclined to Both Reference Planes (Change of Reference Line Method): [ Ссылка ]

Pentagonal Pyramid Inclined to Both Reference Planes (Change of Reference Line Method: [ Ссылка ]

Projections of Solids- 3 Problems in Just 18 Minutes: [ Ссылка ]

Introduction to Development of Surfaces of Solids: [ Ссылка ]

Development of Prism and Cylinder by using Parallel Line Development Method-
[ Ссылка ]

Development of Square Pyramid By Using Radial Line Development method:
[ Ссылка ]

Development of Cone By Using Radial Line Development method :
[ Ссылка ]

Development of Pentagonal Prism with Transverse Square Hole
[ Ссылка ]

Development of Square Pyramid with Axial Circular Hole:
[ Ссылка ]

свернуть