Lithium Titanate Oxide battery build
Around 9.5kWh capacity LTO chemistry
The battery pack was designed so I could have started off with 55cells (5kWh) and later expand it by slotting in upto an extra 44 cells at a later date (when I had more coin), I managed to come up with the coin for a full pack for the build.
Batteries seem solid, although I have seen occasional reports of these batteries venting online. I'm not sure if it was from abuse or design/manufacturing flaw. Will keep you updated with performance of these.
*** am thinking about doing a group buy from a bulk distributor to get the cells at a discounted rate - let me know if interested***
(Update 28/10/20: I have had problems contacting a supplier that I purchased my batteries from. I managed to get hold of them today. The person I dealt with had left so my emails were going nowhere. If you are interested in a group buy for significant discount get in touch brendonsbuilds@gmail.com I will be going through the details of this with the supplier this week and will be in touch).
Affiliated aliexpress link: unfortunately the ali store I bought mine from has stopped selling these cells I have found a store with good reviews and linked below. (be aware that a lot of Aliexpress stores sell reject or low grade cells). Please let me know if you have any trouble with battery capacity from this seller, and make sure to apply for a refund.
[ Ссылка ]
Another store with good feedback - although they have only been operating 6 months or so. If you purchase from there please test cells and let me know if they are meeting capacity and obviously get a refund if not.
[ Ссылка ]
Affiliated link to Internal resistance meter - needed to check cell internal resistance of cells before assembling pack. Will make a video on this.
[ Ссылка ]
Part files: goes without saying... this is not a proven or tested battery pack design, little care, no responsibility.
BUSBAR as tested and shown in video made from 4.5mm thick ali machined - but could be laser cut. Clearances are tight so may have to be opened up if laser cut.
[ Ссылка ]
BUSBAR - slotted from either side, not built or tested. It has slots from either side so that any cell could be changed without having to pull the pack apart:
[ Ссылка ]
BUSBAR brackets, I machined these from Nylon - tho they could be printed (not recommended) have to be aware of creep in plastic on mounting points etc. All cutters are intended to have a 0.5mm corner radius on them to reduce the chance of splitting over time. This design is slightly modified from the video to make the brackets more rugged.
IGS file: [ Ссылка ]
STL file: [ Ссылка ]
Music: Erik Lund - Tokyo Sunset
