If your backup camera does not display colored grid lines then you might want to check if it is grounded properly. This is assuming you connected the positive wire to a power source like your rear tail light already. If this video helps please SUBSCRIBE and LIKE 👍👍👍 Click on SHOW MORE to see tools and instructions.

To help support this channel you can get me a cup of coffee here:
👉👉👉 [ Ссылка ]




This video demonstrates specifically how important and fundamental it is to have a good ground to the frame of a car in order for a backup car camera to work and function properly.


Only 4 🧰 Tools or supplies are needed:

1) Sand Paper: [ Ссылка ] OR Wire brush Set [ Ссылка ]


2) Butt splice [ Ссылка ]


3) Tap screw that fits in the butt splice hole (Buy in store too much online)


4) Black Electrical Tape: [ Ссылка ]




INSTRUCTIONS:


Remove the paint by sanding it down to get to the bare metal (this provides the strong ground connection).

Then place the wire which should be in a butt splice connector on the scratched up area.


Finally drive a tap screw into place. This secures it from movement.


To provide additional protection, cover it up with electrical tape, and bundle up the wires with a zip tie, and then tuck it away.



ℹ️ This video was made because most videos do not explain when installing a rearview backup camera on how to correctly ground the black or ground wire to your car.



Here is a backup camera that you can use: [ Ссылка ]



Hope this step by step guide helps and provides clarity for others!



Please LIKE 👍👍👍 AND SUBSCRIBE 🔔

свернуть