(Links to Parts used at the end)
Video shows,
00:00 - Quick After Video
00:27 - Electrical Plan and Design
17:04 - Test Start
17:56 - Install
26:40 - Floating Ground on Stator
42:13 - Headlight Install
49:36 - Tail Light/Licence bracket make/install
1:02:53 - Test Ride at night
(Links to Parts used at the end)
I'd already installed Treats CDI Adventure Pack Version 2 in video 13, but I just rigged it quickly to be able to run the Motor - No lights or anything. If this video misses anything, its probably in that or number 14 (installing the Stator/Magneto and Timing etc). This video is long enough, so I hopefully skipped or edited down anything I've already shown in previous ones.
I make an aluminum plate to organize the electrical bits under the side covers of the Magnum. I changed things around so the plate will be different in the video as I make adjustments (and I ended up moving from the included regulator to the full bridge rectifier of the TrailTech so the diagram has a few iterations too).
Then floating the ground on the 12V Coil and running that through a TrailTech 7004-RR150 Regulator/Rectifier with a Bat-Pac Battery Eliminator - the Regulator needs something like the Bat-Pac, Small Battery Pack or a large Capacitor to work properly - it puts out 7v at idle going to 0v at higher rpm without it. With the Bat-Pac it is around 12v at idle, goes to 14v with a little throttle and stays there through higher RPM's.
I'm using 20W Halogens and bulb adapters for the Headlight and a "vertical fixation RED LED tail light".
Wire's are organized with TechFlex, zip ties etc. I do use dialectic grease on the connections (I show it only being applied to the headlight).
My remaining to-do list is just add Decals and a Black LTD front fender and when I can get a welded clutch bell, install the Hammer Clutch.
Puch e50 CDI complete adventure pack (Magneto, Stator with 12v coil, pietcard CDI ignition box - 2041 etc)
[ Ссылка ]
Bat-Pac -
[ Ссылка ]
Trail Tech Rectifier/Regulator -
[ Ссылка ]
12-Position European-Style Mini Terminal Strip
[ Ссылка ]
Pin Terminals for the Strip
[ Ссылка ]
20w Halogen Bulbs -
[ Ссылка ]
Bulb Adapter -
[ Ссылка ]
Tail Light -
[ Ссылка ]
TechFlex wire loom (I mainly used 3/8" with a small amount of 1/4")
[ Ссылка ]
Brake Switch
[ Ссылка ]
