Installation video for Greenfilm's G-Cling Custom Pre-cut automotive window tint.
This window tint is already pre-cut into the car window's shape so we proceed to apply the tint directly.
Before Application:
Be sure all windows are clean and free of dust/debris. You can clean the window with the solution and squeegee.
Step 1: Roll window down 3 inches. Place dry film onto the window. Spray generously to allow any dirt to drip off the film.
Step 2: Adjust film leaving 3/8 inch from the top of the film to the top of the window.
Tip: Lift edges of the film and apply the solution to adjust smoothly.
Step 3: Spray then squeegee from the center to the top, then from the center to all edges making sure all bubbles are removed.
Tip; If the film does not reach the edge of the window, you can gently stretch the film to fill the gap.
If any bubbles remain, you can spray and squeegee again.
Tip: Be sure to use the squeegee on wet film to prevent damage.
Step 4: Roll up the window. Spray the solution on and under the film.
Step 5: Squeegee the bottom half of the window.
Tip: Use the small yellow squeegee to gently insert the film into the side of the window.
Step 6: Use the gasket push stick with the squeegee to push the film into the window seal.
Then use the yellow squeegee to remove any remaining bubbles.
Step 7: Spray the film and squeegee again to ensure all edges are flat and all bubbles are removed.
Tip Use tip of the large squeegee to ensure the film is inserted into the edges of the window.
Installation is done! Do not roll windows down or use the suction cup for 48 hours.
For more information, please visit [ Ссылка ]
Or contact us at info@greenfilmusa.com
