Check Out Our FREE GUIDE: *25 Must-Have Carpentry Tools...Under $25 Each!*
[ Ссылка ]

AFFILIATE TOOL LINKS:
Swanson 7" + 12" Speed Square Pack (Best Seller!):
[ Ссылка ]
Swanson Big 12" Speed Square:
[ Ссылка ]
Swanson 7" Speed Square w/ Blue Book:
[ Ссылка ]
Makita 7-1/4" Magnesium Circular Saw (Best Seller!):
[ Ссылка ]
Dewalt 7-1/4" Circular Saw (Best Deal):
[ Ссылка ]
Irwin Quick-Grip Clamps 6" 4-Pack:
[ Ссылка ]
Irwin Quick-Grip 6"+12" 4-Pack:
[ Ссылка ]
Kreg Circular Saw Track Guide:
[ Ссылка ]
Bora QuickCut Circular Saw Guide:
[ Ссылка ]

(Please Note: These are AFFILIATE LINKS. When you shop through these links, we receive a small commission at NO EXTRA CHARGE TO YOU. We greatly appreciate the support!)

Be sure to visit us at The Honest Carpenter Website:
www.thehonestcarpenter.com

One of the most common types of cuts you'll have to make with a circular saw is the CROSSCUT. This short video from The Honest Carpenter will show you how to make the fastest, easiest crosscuts possible with the circular saw, and very simple tools and techniques!

Circular Saw Basics: EASIEST CROSSCUTS!! (6 Tips For Fastest, Easiest Circular Saw Crosscuts!)

Circular saws intimidate new DIYers because they're a FREEHAND TOOL, meaning that they have no system of guides built in to keep them on track.

To make very accurate circular saw crosscuts, I believe that you need a guide that is easy to use, and always at hand.

I prefer to use the common SPEED SQUARE.

By holding the speed square against the edge of a board, you can use it as a guide for the edge of the sole plate of your circular saw.

I like to keep the bar of the speed square along the edge of the board nearest to me--though some people hang the bar from the far edge.

It's often a good idea to clamp your speed square before making your circular saw cut. Just be sure that the clamp is not in the way of the circular saw body.

You can also use the speed square to make ANGLED CUTS with the circular saw!

Just pivot the speed square at the corner until the correct angle number is aligned with the edge of the board. Then, use the edge of the speed square like normal as a guide for the edge of the circular saw sole plate.

It's a good idea to clamp down your board as well to prevent movement or wandering.

Just remember: CIRCULAR SAWS ARE DANGEROUS!

This video is just a source of information. It's up to you to use tools safely! Follow all safety instructions in your manual, and be sure to seek help or guidance from a professional if you need it. Never make a cut if you feel that it's unsafe to do so!

Thanks for watching!

The Honest Carpenter

свернуть