Disclaimer:
Under no circumstances will Paddy’s DIY be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Paddy’s DIY or a third party.

In no event shall Paddy’s DIY be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Paddy’s DIY, it cannot guarantee against improper use or unauthorized modifications of this information.

Paddy’s DIY assumes no liability for any property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Paddy’s DIY recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Paddy’s DIY, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Paddy’s DIY.


Welcome to another amazing video from Paddy's DIY

In this video I'm going to be showing the two methods I use get perfect door seal corner joints. This seal is the joinery seal that is most common in Ireland. It is a type of kerf seal. The kerf being the channel that the seal sits into. Kerf is a term that's not used in Ireland and the UK.

The first method requires very accurate cuts. I'm using a special shears for cutting seals at angles. You will need two perfect 45 degree cuts for this to work. I use superglue on one of the seals and superglue activator on the other one. When the glue sets it will give you a perfect joint.

The second method is the one I use 99.9 percent of the time, and the method I would recommend you use. As it doesn't require any special tools or glue. Push the seal into the channel and mark the inside rebate and outside rebate and cut with a scissors. Don't cut the whole way through,
stop right at he edge. Push the seal into the opposite channel and line up the cut with the outside rebate edge. Mark the inside rebate and cut with a scissors. Stopping at the edge again. Now fold the seal to form a perfect 90 degree angle and a perfect corner joint.

Alternatively instead of using superglue, you could try melting slightly one edge of the seal with a soldering iron of the likes and
quickly sticking it to the other seal. I haven't tried this but I'm sure it would work too.

Thanks for watching. Please like and subscribe

свернуть