In this video, I make a Steel Knot by Bending Rebar, without using heat.
The knot is called a Prusik Knot

This knot will be used in a future Industrial Style project. I love the look of industrial-style furniture and rebar with knots fits right in with the look I like.

I hope you enjoy my video of the project, it was a lot of fun to make.

The main tools used were a Hammer and a bench vise.

Tools / Supplies, I often use are.

Marking out Tools
Markal Silver-Streak Metal Marker Round: [ Ссылка ]
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: [ Ссылка ]
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: [ Ссылка ]

Locking Pliers – Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw: [ Ссылка ]
Milwaukee 6" Long Nose Locking Pliers: [ Ссылка ]
Milwaukee 6” Locking Clamp Regular Jaws: [ Ссылка ]
KNIPEX Tools Long Nose Grip Pliers: [ Ссылка ]

Magnets
Magnetic V-Pads Kit, Magnets On Both Pad Face & Bottom: [ Ссылка ]
Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: [ Ссылка ]
“L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: [ Ссылка ]

My camera set-up.
Canon EOS M6 Mark II Camera 15-45mm Lens: [ Ссылка ]
VideoMicro Rode Compact On-Camera Microphone: [ Ссылка ]
Camera Tripod Vanguard Alta Pro 2: [ Ссылка ]

The Brand of the Drill bits, and cutting/flap discs, is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: [ Ссылка ]

As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!

►►Subscribe to our Channel for more videos ►► [ Ссылка ]
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.

Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY

Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.

свернуть