Buy replacement rear CV boots for your Polaris Ranger: [ Ссылка ]

We’ll show you how to get your Polaris Ranger rear CV boot replacement done right in this video from Partzilla.com. We’ll start by disconnecting the hub from the upper A-arm, which should give us enough room to lower the hub down on the lower A-arm, using it like a hinge to expose the drive shaft. Then we’ll pull the drive shaft.

Replacing the rear CV boots on a Polaris Ranger involves replacing both an inner and outer boot. The outer is the one just behind the wheel, and the inner is at the other end of the drive shaft. We’ll show you a couple if different ways to get the boots off, and then we’ll install the inner or inboard boot first. Then we’ll tackle the outer boot. IMPORTANT TIP: Get the small clamp for the outer boot slid onto the drive shaft before you install the boot. Otherwise, you’ll have to take the boot back off again to get it in place. When we’ve got the rear CV boots replaced on our Ranger, we’ll reinstall the drive shaft and get the wheel back on.

Read how to do this job step by step: [ Ссылка ]

Looking for the front CV boot replacement on a Polaris Ranger? Check it out here: [ Ссылка ]

VIDEO HIGHLIGHTS:
Disconnecting the hub - 1:55
Removing the drive shaft - 2:20
Removing old boots - 2:40
Removing CV joint - 3:45
Installing inner CV boot - 4:30
Installing outer CV boot - 6:15
Reinstalling drive shaft - 7:24

Buy OEM Polaris Ranger 900 XP parts here:
[ Ссылка ]

Talk to us:
Twitter: [ Ссылка ]
Facebook: [ Ссылка ]
Instagram: [ Ссылка ]

In the video we’re working with a 2016 Polaris Ranger 900XP. You may have similar steps on your machine. If you’re not sure whether these steps apply to your vehicle, leave a comment and we’ll get back to you.

RELATED CONTENT:
Polaris Ranger rear diff service:
[ Ссылка ]

Polaris Ranger oil change:
[ Ссылка ]

свернуть