Here's is a video showing how to attach the mask drink tube coupler into a CBR50i CamelBak or canteen. [ Ссылка ]

These are available here: [ Ссылка ]

Parts Needed:
[ Ссылка ]. Make sure the HydroLock is in the OFF position.
For US government canteens, you'll need an Avon canteen cap:
[ Ссылка ]
To connect mask with non-Avon CBRN CamelBak's will need:
[ Ссылка ]

Read the manuals for full instructions. In a CBRN environment, the components must be clean of contaminants before attaching any water source. Here's a summary of how it works. Again, follow Avon Protection published instructions always.
• Unplug the mask drink tube connector from the storage pocket under the front module and unwrap the external drink tube.
•If using a CBR50i camelback, Remove the Big Bite Valve Adapter so the Type A connect is exposed. For canteens, open the canteen cap drink tube connector cover (do not remove the canteen cap).
*Push the drink coupler fully into the Type A Connector or canteen cap connection.
• Turn the drink valve ON by rotating the small lever located on the left side of the front module. This rotates the internal drink tube towards the mouth.
• Hold the canteen upside down at eye level and blow into the internal drink tube to pressurize the canteen. Drink as required. When finished drinking blow through the internal drink tube to clear water from the drinking tube.
• Turn the lever in the opposite direction to turn the valve OFF to move the internal drink tube to the side of the respirator facepiece. Ensure the valve is in the position prior to disconnecting the canteen.
• Uncouple the canteen by pulling the drink coupler from the canteen cup. Do not unscrew the cap. Stow the external drinking tube and coupler within the drink coupler receptacle provided on the respirator.

свернуть