Click for more info and reviews of this Optronics Trailer Lights:
[ Ссылка ]
Check out some similar Trailer Lights options:
[ Ссылка ]

[ Ссылка ]
Don’t forget to subscribe!
[ Ссылка ]

Full transcript: [ Ссылка ]
Today on our equipment trailer, we're going to be installing the Optronics LED trailer clearance, side marker light, part number MCL57AB. We're going to first need to remove the old light from the rubber grommet. To do this, we'll just simply use a flat head screwdriver; work the old light out of the grommet. Here's what the connection looks like on the back side. It's a two prong plug that we just need to simply unplug for now. Here's what our new Optronics light looks like. It is an LED style, not the old incandescent style.

If you'll notice, it has exactly the same plug on the back side and there's also a little bit of dielectric grease already installed at each of the two connection points. The dielectric grease will give you a good connection over the life of the light. Now before we can reinstall our light in our grommet here, we're going to go ahead and clean the grommet out a little bit. Go ahead and get all the dirt that's built up inside the grommet out before we install our new light. Now with our grommet cleaned up, we'll go ahead and take our plug and reconnect it to the back side of our new light. We'll line up each of the two prongs and push firmly making sure that the connection goes all the way in. Now before we put the light back into place, we're going to go ahead and turn it on and make sure it works.

As you can see here, here is what our new Optronics LED side marker light looks like. Now that we've made sure that the light works, we'll go ahead and put it back into the rubber grommet. Now to help the light slide back into the grommet a little easier, we're going to smear just a little bit of grease around the edge of the grommet here. That way the light goes back into place just a little bit easier. Now it will be a little tight when you're putting the light back into the rubber grommet; that is why we added the grease. But you will still need to work at it a little bit in order to get the light to fully seat back in the grommet.

Once we have the light back in, we'll go ahead and take a paper towel and clean up any excess grease that may be on the rubber boot. And that's all there is to it, to installing the Optronics LED trailer clearance and side marker light in the 2 1/2 inch round and amber color, part number MCL57AB. .

свернуть