This video is an excerpt from Paulson Training Program's Sheet Extrusion Techology interactive video training course. This particular excerpt is from Lesson #2 -- Sheet Extrusion Dies - Proper Setup and Maintenance.
There are total of 7 lessons of training in Sheet Extrusion Technology. This represents approximately 10-12 hours of total training.
Having a thorough understanding of the parts and operation of the sheet extrusion die is perhaps one of the most important training lessons sheet extrusion companies should provide to their employees. This lesson teaches the right from the start so that you are assured that everyone on the production floor has a uniform understanding of the sheet die and everyone uses the same language.
Below is a list of all 7 lessons in the training program:
Lesson 1 -- The Sheet Extrusion Line: Parts and Operation
Lesson 2 -- Sheet Extrusion Dies
Lesson 3 -- Controlling Plastic Flow in the Die
Lesson 4 -- Plastic Behavior in the Sheet Extrusion Line
Lesson 5 -- Pre-Start, Start-up, and Steady-State Operating Procedures
Lesson 6 -- Safety and Shutdown Procedures
Lesson 7 -- Troubleshooting the Sheet Extrusion Line
